| 1. | In general, experience has shown that third-to fifth-degree polynomials produce sufficiently low residuals and monotonically increasing derivatives .
实践证明，三至五次多项式就能产生足够小的残差和单调递增的导数。 |
| 2. | Toolox44 belongs to the low residual stress tool steel with hardening and high tempering
Toolox44是经过硬化高温回火的低残余应力工具钢。 |
| 3. | Optimisation of specific chemical synthesis now allows a low residual fatty acid level
目前，特定的化学合成最优化可以允许用一种低标准剩余脂肪酸。 |
| 4. | If low residual stress and better residual stress distribution map are expected , a12o3 ceramic substrate is a better choice compared to fr4
在降温过程中，剪切应力的绝对值逐渐从一个较高水平逐渐开始减小，并趋于平衡。 |
| 5. | In order to lower residual heat on the surface of the block , the cooling mans is installed in interwall of the block . the wortle is soaked in cooling watr to reduce its working temperature
卷筒内壁设备有冷却喷水装置，以降低拉拨后的钢丝传道线卷筒表面的残余热量，拉拨模具的工作温度。 |
| 6. | The sodium silicate sand prepared with higher modulus sodium silicate has advantages of low residual strength , short co2 blowing time , high moisture absorption ability and surface stability
摘要使用较高模数的水玻璃混制的型砂具有残留强度低、吹co2间短等优点，并有好的抗吸湿性和表而稳定性。 |
| 7. | If low residual stress and better residual stress distribution map are expected , adhesives with low cte is preferred , which could be a criteria to select organic adhesives
使用热膨胀系数较小的有机粘合剂粘贴芯片时，可获得较低的残余应力和相对优越的应力分布。该规律可以作为选择有机粘合剂时的参照。 |
| 8. | The main idea of our algorithm is to avoid choosing nodes with lower residual energy as cluster - heads , thus to ensure balanced energy - usage among the nodes in the network
算法通过综合考虑候选节点的剩余能量级、通信能量损耗等参数来优化簇首的选择，从而有效地避免了低能量节点被选为簇首的可能性，进一步保证网络内节点能量负载的均衡性。 |
| 9. | The optimum condition in hydrogen desorption pressure is p = 800 - 100000pa . comparing the magnets prepared by traditional ball milling process , the magnets prepared by hydrogen desorption have lower residual magnetization and maximum magnetic energy product
最佳的脱氢气压在800 - 100000pa之间hd法制备的烧结ndfeb永磁体的剩磁和最大磁能积比传统bm工艺稍低。 |
| 10. | A design of using lpcvd silicon - rich silicon nitride of low residual stress as the resonant beam is proposed based on technology of sacrificial porous silicon and a new type peninsula structure is also proposed for high pressure sensitivity
提出了基于多孔硅牺牲层技术的利用lpcvd生长的低应力厚的富硅氮化硅作为谐振梁的压力传感器结构设计。为了提高灵敏度，还提出了一种半岛结构。 |
